Configuring VPN
VeriSign™ Identity Protection configuration
Cisco SA500 Series Security Appliances Administration Guide 170
7
STEP 3 In the Upload Certificate area, complete the following tasks:
a. Certificate File: Click Browse, and then find your VeriSign certificate (RA) file.
a. Password for the certificate file: Enter the password that was provided to you
along with the certificate (RA) file. The password encrypts the private key
provided in the certificate and is required to decrypt and use it.
b. Click Upload to upload the certificate.
Managing User Credentials for VeriSign Service
Use this page to associate VeriSign tokens with your users.
NOTE Your users must be configured in Administration first. See Users, page 171.
STEP 1 Click VPN > VeriSign ID Protection > Credential Management.
The VeriSign Credential Management window opens.
STEP 2 To add a credential, click Add.
Other options: Click the Edit button to edit an entry. To delete an entry, check the
box and then click Delete. To select all entries, check the box in the first column of
the table heading.
After you click Add or Edit, the VeriSign Credential Configuration window opens.
STEP 3 Enter the following information:
• Credential Id: Enter the 6-digit alphanumeric number, which is typically
found on the back of the physical token. Each credential identifier must be
unique and must not be added if it is already present in the token
configuration table.
• User Name: Choose the user to associate with the token number. Each
credential identifier can be associated with only one user. After the user has
been associated with a credential, the same user cannot be associated with
a different credential. Only available users are shown in the user list.
STEP 4 Click Apply to save your settings.
To Next Page
Loading...
Need help?
General
