Cisco WS-CE500 - Restoring Factory Default Configuration Settings

Troubleshooting
Restoring Factory Default Configuration Settings
Cisco SA500 Series Security Appliances Administration Guide 223
A
Restoring Factory Default Configuration Settings
To restore factory default configuration settings, take one of the following actions:
• Launch the Configuration Utility and login. Click Administration > Firmware
& Configuration > Network. In the Backup/Restore Settings area, click
Default.
OR
• Press and hold the Reset button on the front panel about the security
appliance for about 10 seconds, until the test LED lights and then blinks.
Release the button and wait for the security appliance to reboot. If the
security appliance does not restart automatically; manually restart it to make
the default settings effective.
After a restore to factory defaults, the following settings apply:
• LAN IP address: 192.168.75.1
• Username: cisco
• Password: cisco
• DHCP server on LAN: enabled
• WAN port configuration: Get configuration via DHCP