Network Management
RMON (Remote Management)
Cisco SA500 Series Security Appliances Administration Guide 198
9
STEP 1 Click Network Management > Remote Management.
The Remote Management (RMON) window opens.
STEP 2 Enter the following information:
• Enable Remote Management?: By default, Remote management is
disabled. To enable WAN access to the configuration GUI check the box.
IMPORTANT: When you enable remote management, the security appliance
is accessible to anyone who knows its IP address. Since a malicious WAN
user can reconfigure the security appliance and misuse it in many ways, we
strongly recommend that you change the admin and guest passwords
before continuing.
• Access Type: Choose the level of permission for remote management:
- All IP Addresses: If this option is selected, make sure that you change
the default password.
- IP Address Range: If this option is selected, enter the From: starting IP
address for the allowed range and To: ending IP address for the allowed
range.
• Only this PC: If this option is selected, set the following:
- IP Address: IP Address of the PC given remote management
permissions
• Port Number: Displays the port number used for the remote connection.
• Remote SNMP Enable: Check the box to enable SNMP for the remote
connection.
STEP 3 Click Apply to save your settings.
To Next Page
Loading...
Need help?
General
