Cisco WS-CE500 - Page 232

Factory Default Settings
Router Settings
Cisco SA500 Series Security Appliances Administration Guide 232
D
HTTPS Remote Access enable
WAN1 IP address assignment DHCP client
WAN1 - MTU 1500
WAN1- Outgoing Traffic
Bandwidth Limit
disable
Allow ICMP echo replies (good
for validating connectivity)
disable
HTTPS Remote Access disable
WAN2 IP address assignment DHCP client
WAN2 - MTU 1500
WAN2- Outgoing Traffic
Bandwidth Limit
disable
Allow ICMP echo replies (good
for validating connectivity)
disable
HTTPS Remote Access disable
Routing (RIP1/2) disable
Inter-VLAN routing enable / disable on DMS VLAN
Static Routing disable
IPv4 and IPv6 IPv4 Only
IPSec - Signaling Authentication
- Key Exchange Method
Automatic
IPSec - Signaling Authentication
- Auto Reconnect
enable
IPSec - Signaling Authentication
- Local Subnet (Data VLAN
subnet)
192.168.10.0
IPSec - Signaling Authentication
- Local Subnet (Data VLAN
subnet mask)
255.255.255.0
Feature Setting