3.4.1.1 Intelligent linking
For intelligent linking, shielded CAT5 cable is run from a port on one Eclipse HX-
Delta matrix to a port on a second Eclipse HX-Delta matrix to form a trunkline
connection.
3.4.2 E-FIB fiber interface card
E-FIB fiber interfaces connect Eclipse HX matrices together to provide a high
speed, dual redundant link to transfer audio samples and data between systems.
These connections can be configured to provide protection against the loss of a
link or a node.
Each E-FIB fiber interface card set comprises:
• A front card with various status indicators.
• A rear card with two Duplex LC Terminated fiber optic connectors
(TXVRA and TXVRB).
3.4.3 E-QUE interface card (for FreeSpeak
®
/CellCom
®
and
FreeSpeak II™ connections and E1 / T1 trunk lines)
The E-QUE interface card allows the Eclipse HX-Delta to connect to
FreeSpeak/CellCom/FreeSpeak II antennas, FreeSpeak/CellCom/ FreeSpeak II
antenna splitters, and E1 and T1 trunk lines.
Each E-QUE interface card set comprises:
• A front card with a reset button and various status indicators.
• A rear card with eleven RJ-45 ports giving eight standard Ethernet ports,
DECT sync in and out and a LAN port for diagnostic use.
Each E-QUE front card has status LEDs for power, port activity and LAN status.
The port activity LEDs show when
• A device is connected to an E1 port.
• A connection has been established between the E1 port and the
connected device.
3.4.4 E-MADI64 MADI interface card
The E-MADI64 is a MADI (Multichannel Audio Digital Interface) card, providing
up to 64 duplex channels of AES3 digital audio over a coaxial cable or fiber pair
between compatible devices.
Note: You have the option in EHX to limit the E-MADI64 card to either 32, 56 or 64
channels of audio. All MADI channels have standard EHX settings, including VOX
and in-use tally.
The E-MADI64 card supports up to 32 V-Series Panels over a suitable
infrastructure. See 6.5 V-Series Panels on E-MADI (Multi-channel Audio Digital
Interface) for more information
To Next Page
Loading...
