ComAp InteliDrive DCU Industrial - Page 14

InteliDrive DCU Industrial 3.4.0 Global Guide
14
Sd CommError(1) to (10) SD
Wrn DETCON WRN
Sd DETCON SD
Wrn SCM Fail WRN
Sd SCM Fail SD
Start fail WRN YES
ParamFail NONE
Overspeed SD YES
Underspeed WRN YES
EmergencyStop SD
Pickup fail WRN
Stop fail WRN YES
WrnServiceTime WRN
ChrgAlternFail WRN YES
Fault reset
LOC mode ON YES
LOC mode OFF
Harbour mode ON YES
Harbour mode OFF
SecBattery YES
ID-RPU Sd1 Broken wire WRN
ID-RPU Sd2 Broken wire WRN
ID-RPU Sd3 Broken wire WRN
ID-RPU Sd4 Broken wire WRN
ID-RPU Sd5 Broken wire WRN
ID-RPU Stop sol.Broken wire WRN
ID-RPU Fuel sol.Broken wire WRN
Wrn RPM diff WRN YES
Engine events Note
Starts
Button start Start from ID-DCU Industrial panel
CAN control + Button
start
Start from ID-DCU Industrial
RS232 control + Button
start
Start from InteliMonitor
Remote start ID-DCU Industrial binary input
RemRepStart ID-DCU Industrial binary input
Blackout start ID-DCU Industrial binary input
Button start ID-DCU Industrial panel button