ComAp InteliDrive DCU Industrial - Page 285

InteliDrive DCU Industrial 3.4.0 Global Guide
285
Terminals
ANALOG INPUT 8 analog Inputs
IMPULSE INPUT 1 impulse input
CAN CAN1 line
POWER Power supply
CAN LED Tx, Rx Indication transmitted or received data
Status LED LED indication of correct function
CAN terminator Terminating CAN resistor (active in position “ON”)
TEST jumper Upgrade of sw
AT-LINK Connector for AT-LINK
Address and DIP switch setting
Address configuration
DIP switch determinates CAN address for analog inputs and impulse input too.
Programming Firmware
Firmware upgrade is via AT-link (TTL). For programming it is necessary to close jumper TEST.
For programming use FlashProg PC tool version 4.2 or higher.