ComAp InteliDrive DCU Industrial - Page 286

InteliDrive DCU Industrial 3.4.0 Global Guide
286
LED indication
LED at power connector – status LED
LED status Description
Dark Fw in module does not work correctly.
Flashing Module does not communicate with controller (in case non-zero CAN address)
Fast flashing Detection of CAN communication speed
Lights
Power supply is in the range and the communication between Inteli AIN8TC and
controller works properly.
Or power supply is in range and zero CAN address is set. (in case zero CAN
address module doesn’t communicate with the controller)
Impulse input configuration
(This input is supported in sw IGS-NT3.0 and higher)
(InteliGen-NT and InteliSys-NT support 1 impulse input (type Impulse or Impulse/time or
Impulse+Impulse/time) and 1 RPM input or 2 RPM inputs)
After adding Inteli AIN8 module to configuration in DriveConfig / card Modules, you choose type of impulse
input:
After selection you configure input - in card “I/O”, group “Impulse input”
RPM
In this case you can set name of this input and set the number of gear teeth.
Value of RPM is placed in value group: “RPM & Imp/time“