120 9 Troubleshooting
3.16 ERROR 51 ~ ERROR 61 System Errors
Usually system errors (ERROR 51 through ERROR 61)are caused by
malfunction of electrical components.
System Errors
ERROR 51 Lo Battery SRAM Error Probable Cause 1
The battery has discharged completely.
Treatment 1
If this error occurs, none of the measurements is enabled.
Replace the battery instantly following the procedures in the
manual (8 Maintenance).
Probable Cause 2
If the same error occurs after replacing the battery, some
electrical parts may be malfunctioned.
Treatment 2
Contact Cosmo for repair after executing a System Backup
I/O Communication failure
Flash data area bad track Error
Flash program area WR Error Kernel
Contact Cosmo for repair after executing System Backup.
System Backup
1) Switch the operation mode to Manual(M)
2) Press ■ on a measurement screen to cancel the error
message.
Rebooting LS-R700 also cancels the error.
3) Insert a USB memory into the USB port on the front panel.
4) Execute the System Backup.
> Main Menu > System > System Backup/Restore
> Backup > “Initiating System Backup OK to continue?”
> Yes
Output Signal Timing Chart
PIN#
Function TYPE WAIT
System Restore Procedure
1) Insert a USB memory into the USB port on the front panel.
2) Execute the System Restore.
> Main Menu > System > System Backup/Restore > Restore
> “Initiating System Restore OK to continue?” > Yes
“Backup file is not found Restore failed.” is displayed if USB
memory is not inserted or the Backup file is not in the USB
memory.
ERROR 51 (Lo Battery SRAM
Error) may cause because of the
battery life.
Mastering Value, Compensation Value and Counter
are reset after entire System Restore.
To Next Page
Loading...
Need help?
General
