COTRUST CTH200 Series - 2.3 Create Program Network

To Next Page

To Previous Page

Getting Started

Step 1 Step 2 Step 3

2.2.3 Modify IP Address in System Block

After establishing communication connection, you can modify the IP address of CPU through the

System Block in MagicWorks PLC.

Note: downloading the System Block into PLC to make the modification effective. Then you need

to search PLC again to establish connection (refer to chapter 2.2.2 Ethernet Communication

Mode)

2.3 Create Program Network

This section describes how to create, download and run PLC program for CTH200 PLC. The

following program examples use 3 instructions to shift left 1 bit for value transferred in QB0 at 1s