Secon 5 - Engineer’s Program
Technical Manual
3. Remove Languages - this removes current languages installed on the machine. As a
safe guard you cannot remove all languages from the machine.
4. Copy Languages to USB - this enables the language being used in the current
conguraon to be copied to a USB sck for translaon to a required language
5. Service Applicaon - this enables the selecon of the language to be used on all
screens accessed by service engineers is chosen.
6. User Interface - this enables the selecon of languages that are available for selecon
by the consumer (user). The default language is the one the display will revert to aer
there being no interacon for 20 seconds.
5.11.10 DTS
This menu enables the conguraon of the data transfer standard to send audit data
relang to sales and events via telemetry or to a hand held device.
The machine uses the EVA-DTS (Data Transfer Standard) to ensure it is compable with
industry standard external devices and systems.
5.11.10.1 DTS Standby Mode
This menu allows you to choose the data transfer format:
1. DDCMP IrDA - data can be downloaded from the machine using a hand held infra red
DDCMP device.
2. DEX - data can be downloaded from the machine by plugging a DEX enabled device
into the DEX port (J16) on the main control board.
3. DDCMP Wired - data can be downloaded via a hard wired DDCMP device.
5.11.10.2 DTS Audit List
This menu allows you to choose which data elds will be transferred from the machine.
5.11.10.3 CA304 Data Type
This menu determines whether the data will be displayed as Currency or Numeric.
1. For example, assuming that the value of pound coins in the machine is £3.00, when set
to Currency CA304 will read 300 in the DEX/DDCMP report.
2. When set to Numeric it will read 3.
5.11.10.4 Data Reset Mode
This menu enables all reseable data to be either saved or reset to zero, select:
1. Auto - to reset the data aer a successful read.
2. Save - to save the current data values held on the machine.
5.11.10.5 Event Reset Mode
This menu enables all event data to be either saved or reset to zero, select:
1. Auto - to reset the event data aer a successful read.
2. Save - to save the current data held on the machine.
To Next Page
Loading...
