CPI COTI - Page 106

Secon 5 - Engineer’s Program
5.11.10.6 Baud Rate
This enables the correct baud rate for a serial printer to be set. It is important for this to be
set correctly to ensure successful data transfer.
5.11.10.7 Passcode Reset
This opon enables the passcode to be reset, a conrmaon is required before the reset
occurs.
Data collecon is passcode protected, but the machine is able to remember the passcode
of the collecon device. If a dierent device is used that the machine does not recognise
the passcode must be reset to enable the transfer of data.
5.11.11 Screen Brightness
This menu enables the brightness of the drink selecon screen to be adjusted for normal
operang mode and also when the machine is in Power Saving Mode.
5.11.12 Update Adversements
This opon allow Adverts to be loaded which will run at set mes of the day instead of the
Standby Screens. They can be loaded vis USB sck or OTA with Crane’s Simpli telemetry
system.
5.11.13 Soware Updates
This menu enables new conguraons to be uploaded onto the machine, via a USB sck or
OTA via Simpli.
5.11.14 Backup/Restore
This enables a backup of the current conguraon on the machine and the ability to restore
the default or any of up to ten conguraons previously stored on the machine.
1. Make New Backup - follow the on screen
instrucons to save the current machine conguraon.
2. Available Backups - this enables a default
conguraon or any backups previously saved on this
machine to be selected and loaded.
5.11.15 Clone Sengs
This enables selected elements of a machine’s conguraon to be cloned and loaded onto
other machines. A generic USB sck with a folder named atlas is required
96