Secon 5 - Engineer’s Program
a. Select Switch Ingredient
b. Select the required ingredient canister
c. Select Up one level
6. Milk, Sugar and Instant Coee – these ingredients can be adjusted to oer dierent
strengths to the user and appear in this menu as for example Milk 1, Milk 2 and Milk 3,
where Milk 1 is the least amount of milk and Milk 3 is the most. The strength is
measured in seconds or grams and ml and controls how long the ingredient motor
runs and is known as the ingredient throw.
7. Strength Increment Size - Depending on the conguraon being used this may allow
you to choose how many strengths of each ingredient are available for the drink you
are seng up
8. Water Quanty - how long the water valve is opened. Always ensure there is sucient
water to clear the mixing bowl of ingredient.
9. Product Delay - to delay the adding of product aer a valve opens.
10. Whipper Time - how long the whipper runs for.
11. Whipper Delay - to delay the whipper aer a valve opens.
12. Pre Dispense Delay - this is set to opmum value and should not be adjusted.
13. Post Dispense Delay - this is the length of me aer the ingredient has been vended
before the next ingredient is dispensed or the head returns to its park posion.
14. Vend Without Cup - This allows a drink to be vended using the new sengs you have
just adjusted. Use the + or - to vary the strength and press Start (no cup will be
dispensed so you must have one ready to catch your drink). It is recommended that
you select the strongest of each of the ingredients and check that all ingredients are
cleared from each mixing bowl.
To Next Page
Loading...
