D-Link DGS-3120-48PC - Page 233

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
229
Example
To enable DHCPv6client packet sending debug flags:
DGS-3120-24TC:admin#debug dhcpv6_client packet sending state enable
Command: debug dhcpv6_client packet sending state enable
Success.
DGS-3120-24TC:admin#
22-11 debug dhcpv6_relay state enable (EI Mode Only)
Description
This command is used to enable DHCPv6 relay debug functions.
Format
debug dhcpv6_relay state enable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 relay debug function:
DGS-3120-24TC:admin#debug dhcpv6_relay state enable
Command: debug dhcpv6_relay state enable
Success.
DGS-3120-24TC:admin#
22-12 debug dhcpv6_relay state disable (EI Mode Only)
Description
This command is used to disable DHCPv6 relay debug functions.
Format
debug dhcpv6_relay state disable