xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
230
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable DHCPv6 relay debug functions:
DGS-3120-24TC:admin#debug dhcpv6_relay state disable
Command: debug dhcpv6_relay state disable
Success.
22-13 debug dhcpv6_relay output (EI Mode Only)
Description
This command is used to set the debug message to output to a buffer or a console.
Format
debug dhcpv6_relay output [buffer | console]
Parameters
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set debug information to output to a console:
DGS-3120-24TC:admin#debug dhcpv6_relay output console
Command: debug dhcpv6_relay output console
Success.
DGS-3120-24TC:admin#
To Next Page
Loading...
