EasyManua.ls Logo

Danfoss Turbocor TT Series

Danfoss Turbocor TT Series
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6. ContinuetoSection4.11.2.43-PhaseMainVoltageInputTerminalBlockInstallation-TTS300/TGS230
onpage104.
4.11.2.3 3-Phase Main Voltage Input Terminal Block Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230)
1. Disconnectthethree(3)connectorsoftheSoftStartAC/DCharnessfromthebusbars.
2. Removethethree(3)fastenersthatsecuretheACBusBarstotheSCRs.ForRevisionFandearlier
compressors,refertoFigure4-82InputTerminalBlockRemoval-TTS/TGS/TTH/TGHRev.FandEarlier
(ExceptTTS300/TGS230)andforRevisionHcompressors,refertoFigure4-83InputTerminalBlock
Removal-TTS/TGS/TTH/TGHRev.H(ExceptTTS300/TGS230)onpage104forthisandthefollowing
three(3)steps.
3. Removethesix(6)fastenersthatsecurethethree(3)ACBusBarstotheTerminalBlock.
4. RemovetheACBusBars.
NOTE
Iftheterminalblockisbeingremovedtoaccessothercomponents,itisnotnecessarytoremovetheACBusBarsfromtheterminalblock
onRevFandearliercompressors-theterminalblockandbusbarscanberemovedasanassembly.OnRevHcompressors,thecenterAC
BusBarmustberemovedtoaccessamountingfastenerfortheterminalblockbutthetwo(2)outerbusbarscanremainattached.
5. RemovethefastenersthatsecuretheTerminalBlocktothecastingandremovetheTerminalBlock.
a. RevFandearliercompressorsusetwo(2)M5x45fastenersthatattachtheTerminalBlocktothe
compressorhousing.
b. RevHcompressorsusethree(3)fasteners;itusesthesametwo(2)aslistedaboveandthereisan
additionalM6x16fastenerthatislocatedatthebackcenteroftheTerminalBlock(underthecenter
ACBusBar).ThisfastenersecurestheTerminalBlocktotheSCRCoolingManifold.
6. Removethetwo(2)spacersiftheTerminalBlockistobereplacedwithanewone.
7. ContinuetoSection4.11.2.53-PhaseMainInputTerminalBlockInstallation-TTH/TGH/TTH/TGH
(ExceptTTS300/TGS230)onpage105.
Figure 4-82 Input Terminal Block Removal - TTS/TGS/TTH/TGH Rev. F and Earlier (Except TTS300/TGS230)
M-SV-001-EN Rev. H-1/23/2023 Page 103 of 294

Table of Contents

Other manuals for Danfoss Turbocor TT Series

Related product manuals