xii
Driver-Only Messages ______________________________________________________ 76
500: The printer is not available _________________________________________ 76
501: The printer connection was lost ____________________________________ 76
502: The card data is missing or is not usable_____________________________ 76
504: The card data is missing or is not usable_____________________________ 76
505: USB communication issue __________________________________________ 77
506: A card is currently processing ______________________________________ 77
508: The printer is shutting down ________________________________________ 77
509: The printer is offline or suspended __________________________________ 77
Driver SDK Messages _______________________________________________________ 78
511: Cannot lock or unlock the printer. Locks are not installed.____________ 78
512: Cannot lock or unlock the printer. The password is incorrect or invalid. 78
513: Cannot lock or unlock the printer. The printer is busy. ________________ 78
514: Cannot lock or unlock the printer. The cover is open. ________________ 78
515: Failed to lock or unlock the printer. The locks did not function. _______ 78
516: Timeout expired before bar code could be read. ___________________ 78
517: Wrong printer job ID._______________________________________________ 78
Appendix A: SD460 Laminating System___________________________________________ A-1
About the SD460 System _____________________________________________________ A-1
Outside the Laminator ____________________________________________________ A-2
Laminator Back and Left Side _________________________________________ A-2
Laminator Status Light ________________________________________________ A-3
Laminator Front and Right Side ________________________________________ A-3
Inside the Laminator ______________________________________________________ A-4
Laminator Configuration Label ____________________________________________ A-5
Laminator Setup _____________________________________________________________A-6
Laminator Overlay Materials ______________________________________________ A-6
Load Laminator Overlay Material__________________________________________ A-8
Card Design ___________________________________________________________ A-10
Verify Setup ____________________________________________________________ A-10
Clear Laminator Card Jam __________________________________________________A-11
Clean the Laminator ________________________________________________________A-12