Dell Networking N4000 Series - Page 1046

1046 Configuring DHCP Server and Relay Settings
Figure 32-5. Address Pool
Adding a Network Pool
To create and configure a network pool:
1
Open the Address Pool page.
2 Click Add Network Pool to display the Add Network Pool page.
3 Assign a name to the pool and complete the desired fields.
In Figure 32-6, the network pool name is Engineering, and the address
pool contains all IP addresses in the 192.168.5.0 subnet, which means a
client that receives an address from the DHCP server might lease an
address in the range of 192.168.5.1 to 192.168.5.254.