Dell Networking N4000 Series User Manual

Configuring OSPF and OSPFv3 1123
OSPF Area Configuration
The Area Configuration page lets you create a Stub area configuration and
NSSA once you’ve enabled OSPF on an interface through Routing
→ OSPF
→ Interface Configuration. At least one router must have OSPF enabled for
this web page to display.
To display the page, click Routing
→ OSPF → Area Configuration in the
navigation panel. If a Stub Area has been created, the fields in the Stub Area
Information are available. If a NSSA has been created, the fields in the NSSA
Area Information are available.
Figure 35-2. OSPF Area Configuration

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)