Dell Networking N4000 Series - Ipv6 ACL Configuration

606 Configuring Access Control Lists
IPv6 ACL Configuration
Use the IPv6 ACL Configuration page to add or remove IP-based ACLs. To
display the IP ACL Configuration page, click Switching
→ Network Security
→ Access Control Lists → IPv6 Access Control Lists → IPv6 ACL
Configuration in the navigation panel.
Figure 20-8. IPv6 ACL Configuration
Adding an IPv6 ACL
To add an IPv6 ACL:
1
Open the IPv6 ACL Configuration page.
2 Click Add to display the Add IPv6 ACL page.
3 Specify an ACL name.
Figure 20-9. Add IPv6 ACL
4 Click Apply .