Dell Networking N4000 Series - Configuring Acls (CLI); Configuring an Ipv4 ACL

612 Configuring Access Control Lists
Configuring ACLs (CLI)
This section provides information about the commands you use to create and
configure ACLs. For more information about the commands, see the
Dell
Networking N2000, N3000, and N4000 Series Switches CLI Reference Guide
at support.dell.com/manuals.
Configuring an IPv4 ACL
Beginning in Privileged EXEC mode, use the following commands to create
an IPv4 ACL, configure rules for the ACL, and bind the ACL to an interface.
NOTE: The ip access-group command can be issued in Global Configuration
mode or Interface configuration mode. If it is applied in Global Configuration
mode, the ACL binding is applied to all interfaces. If it is applied in Interface
Configuration mode, it is applied only to the specified interfaces within the mode.
Command Purpose
configure Enter global configuration mode.
access-list name Create an extended ACL and enter IPv4 access-list
configuration mode.