Dell Networking N4000 Series - IP Interface Configuration (Default VLAN IP Address)

Setting Basic Network Information 153
Figure 7-1. Out of Band Interface
To enable the DHCP client and allow a DHCP server on your network to
automatically assign the network information to the OOB interface, select
DHCP from the Protocol menu. If you statically assign the network
information, make sure the Protocol menu is set to None.
IP Interface Configuration (Default VLAN IP Address)
Use the IP Interface Configuration page to assign the default VLAN IP
address and subnet mask, the default gateway IP address, and to assign the
boot protocol.
To display the IP Interface Configuration page, click Routing
→ IP →
IP Interface Configuration in the navigation panel.