Dell Networking N4000 Series - Dot1 Ag L2 Ping; Dot1 Ag L2 Traceroute

870 Configuring Connectivity Fault Management
Dot1ag L2 Ping
Use the L2 Ping page to generate a loopback message from a specified MEP.
The MEP can be identified by the MEP ID or by its MAC address.
To display the
page, click Switching → Dot1ag → L2 Ping in the tree view.
Figure 26-10. Dot1ag L2 Ping
Dot1ag L2 Traceroute
Use the L2 Traceroute page to generate a Link Trace message from a specified
MEP. The MEP can be specified by the MAC address, or by the remote MEP
ID.
To display the
page, click Switching → Dot1ag → L2 Traceroute in the tree
view.