Dell Networking N4000 Series User Manual

1212 Configuring RIP
redistribute ospf [metric
metric ] [match [internal]
[external 1] [external 2]
[nssa-external 1] [nssa-
external 2]]
Configure RIP to allow redistribution of routes from the
OSPF.
• ospf — Specifies OSPF as the source protocol.
•
metric — Specifies the metric to use when
redistributing the route. Range: 1-15.
• internal — Adds internal matches to any match types
presently being redistributed.
•
external 1 — Adds routes imported into OSPF as Type-
1 external routes into any match types presently being
redistributed.
•
external 2 — Adds routes imported into OSPF as Type-
2 external routes into any match types presently being
redistributed.
•
nssa-external 1 — Adds routes imported into OSPF as
NSSA Type-1 external routes into any match types
presently being redistributed.
•
nssa-external 2 — Adds routes imported into OSPF as
NSSA Type-2 external routes into any match types
presently being redistributed.
distance rip integer Set the route preference value of RIP in the router. Lower
route preference values are preferred when determining
the best route.
exit Exit to Global Config mode.
exit Exit to Privileged Exec mode.
show ip rip View information about the RIP route distribution
configuration.
Command Purpose

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)