Dell Networking N4000 Series - Page 1419

Managing IPv4 and IPv6 Multicast 1419
console#configure
console(config)#no ip igmp snooping
console(config)#no ipv6 mld snooping
console(config)#vlan 10,20
console(config-vlan10,20)#exit
2 Configure port 23 and 24 as trunk ports.
console(config)#interface te1/0/23
console(config-if-Te1/0/23)#switchport mode trunk
console(config-if- Te 1/0/23)#switchport trunk allowed vlan remove 10
console(config-if-Te1/0/23)#exit
console(config)#interface te1/0/24
console(config-if-Te1/0/24)#switchport mode trunk
console(config-if- Te 1/0/24)#switchport trunk allowed vlan remove 20
console(config-if-Te1/0/24)#exit
3 Enable routing on the switch and configure the OSPF router ID.
console(config)#ip routing
console(config)#router ospf
console(config-router)#router-id 3.3.1.1
console(config-router)#exit
4 Configure VLAN 10 as a VLAN routing interface and specify the OSPF
area. When you assign an IP address to the VLAN, routing is automatically
enabled.
console(config)#interface vlan 10
console(config-if-vlan10)#ip address 192.168.10.4 255.255.255.0
console(config-if-vlan10)#ip ospf area 0
5 Enable IGMPv2 and PIM-SM on the VLAN routing interface.
console(config-if-vlan10)#ip igmp
console(config-if-vlan10)#ip igmp version 2
console(config-if-vlan10)#ip pim
console(config-if-vlan10)#exit
6 Configure VLAN 20 as a VLAN routing interface and specify the OSPF
area.
console(config)#interface vlan 20
console(config-if-vlan20)#ip address 192.168.20.4 255.255.255.0
console(config-if-vlan20)#ip ospf area 0
7 Enable IGMPv2 and PIM-SM on the VLAN routing interface.
console(config-if-vlan20)#ip igmp
console(config-if-vlan10)#ip igmp version 2
console(config-if-vlan20)#ip pim