Dell Networking N4000 Series User Manual

352 Configuring SNMP
snmp-server host host-
addr
[informs [timeout
seconds ] [retries retries ]
| traps version {1 | 2}]]
community-string [udp-
port
port ] [filter
filtername ]
For SNMPv1 and SNMPv2, configure the system to receive
SNMP traps or informs.
• host-addr — Specifies the IP address of the host (targeted
recipient) or the name of the host. (Range:1-158
characters).
•
informs — Indicates that SNMPv2 informs are sent to
this host
•
timeout seconds — Number of seconds to wait for an
acknowledgment before resending informs. The default is
15 seconds. (Range: 1-300 characters.)
•
retries — Maximum number of times to resend an inform
request. The default is 3 attempts.
•
traps — Indicates that SNMP traps are sent to this host
– version 1 — Indicates that SNMPv1 traps will be used
– version 2 — Indicates that SNMPv2 traps will be used
•
community-string — Specifies a password-like
community string sent with the notification operation.
(Range: 1-20 characters)
•
port — UDP port of the host to use. The default is 162.
(Range: 1-65535 characters.)
• filtername — A string that is the name of the filter that
defines the filter for this host. If unspecified, does not
filter anything (Range: 1-30 characters.)
Command Purpose

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)