Dell Networking N4000 Series User Manual

376 Managing Images and Files
boot system {image1 |
image2}
Set the image to use as the boot (active) image after the
switch resets. Images on the N4032/N4064 are named
active and backup .
For N4000 series switches, use the following command:
boot system {active | backup}
reload Reboot the switch to make the new image the active
image.
You are prompted to verify that you want to continue.
Command Purpose

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)