Dell Networking N4000 Series User Manual

622 Configuring Access Control Lists
mac access-group name
direction seqnum
Bind the specified MAC ACL to an interface.
NOTE: To apply this ACL to all interfaces, issue the command
in Global Configuration mode.
• name — Access list name. (Range: Valid MAC access-list
name up to 31 characters in length)
• direction — Direction of the ACL. (Range: In or out.
Default is
in .)
•
seqnum — Precedence for this interface and direction. A
lower sequence number has higher precedence. Range: 1
– 4294967295. Default is1.
CTRL + Z Exit to Privileged EXEC mode.
show mac access-lists
[ name ]
Display all MAC access lists and all of the rules that are
defined for the MAC ACL. Use the optional name
parameter to identify a specific MAC ACL to display.
Command Purpose

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)