Dell Networking N4000 Series User Manual

690 Configuring VLANs
dvlan-tunnel ethertype
{802.1Q | vman |
custom < 0-65535 >}
[primary-tpid]
Configure the EtherType to use for uplink or access
interfaces.
• 802.1Q — Configures the EtherType as 0x8100 (default).
• vman — Configures the EtherType as 0x88A8.
• custom — Custom configures the EtherType for the
DVLAN tunnel. The value must be 0-65535.
• primary-tpid — Configure the primary (outer) TPID. If
this parameter is not present, the inner TPID is
configured. Only a single outer TPID may be configured
for a switch. The inner VLAN TPID can be configured on
all interfaces or on individual interfaces.
CTRL + Z Exit to Privileged EXEC mode.
show dvlan-tunnel Display all interfaces enabled for Double VLAN Tunneling
show dvlan-tunnel
interface {
interface |
all}
Display detailed information about Double VLAN
Tunneling for the specified interface or all interfaces.
Command Purpose

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)