Dell Networking N4000 Series - Page 822

822 Configuring L2 Multicast Features
Figure 25-6. Edit IGMP Snooping Settings
3 Edit the IGMP snooping fields as needed.
4 Click Apply .
The IGMP snooping settings are modified, and the device is updated.
Copying IGMP Snooping Settings to Multiple Ports, LAGs, or VLANs
To copy IGMP snooping settings:
1
From the General IGMP snooping page, click Show All .
The
IGMP Snooping Table displays.
2 Select the Copy Parameters From checkbox.
3 Select a Unit/Port, LAG, or VLAN to use as the source of the desired
parameters.
4 Select the Copy To checkbox for the Unit/Ports, LAGs, or VLANs that
these parameters will be copied to.
In Figure 25-7, the settings for VLAN 21 will be copied to ports 3 and 5.