Dell Networking N4000 Series User Manual

962 Configuring Link Aggregation
Status Reporting
The status outputs of the various VPC commands are self-explanatory. Both
the configured and operational status is shown in the outputs. Additional
commands are shown below that may be useful in troubleshooting MLAG
configuration or operational issues. All of the commands below are run on the
MLAG primary switch except as noted otherwise.
MLAG-Peer-A(config)#show vpc brief
VPC admin status............................... Enabled
Keep-alive admin status........................ Enabled
VPC operational status......................... Enabled
Self role...................................... Primary
Peer role...................................... Secondary
Peer detection admin status.................... Disabled
Peer-Link details
-----------------
Interface...................................... Po1
Peer-link admin status......................... Enabled
Peer-link STP admin status..................... Disabled
Configured VLANs............................... 1,10
Egress tagged VLANs............................ 10
VPC Details
-----------
Number of VPCs configured...................... 1
Number of VPCs operational..................... 1
VPC id# 1
-----------
Interface...................................... Po2
Configured VLANs............................... 1,10
VPC interface state............................ Active
Local Members Status
----------------- ------
Gi1/0/23 Up
Peer Members Status
---------------- ------
Gi1/0/23 Up

Dell Networking N4000 Series Specifications

General

Layer	Layer 3
Switching Capacity	Up to 1.28 Tbps
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Series	N4000 Series
Stacking	Up to 12 units
Power Supply	Dual, hot-swappable
Management	Web, CLI, SNMP
Humidity	10% to 90% (non-condensing)