Dell S4820T - Page 23

Assigning IPv6 Addresses on an Interface.................................................................................. 713
Assigning Area ID on an Interface...............................................................................................713
Assigning OSPFv3 Process ID and Router ID Globally...............................................................714
Assigning OSPFv3 Process ID and Router ID to a VRF...............................................................714
Configuring Stub Areas................................................................................................................715
Configuring Passive-Interface.....................................................................................................715
Redistributing Routes.................................................................................................................. 716
Configuring a Default Route....................................................................................................... 716
Enabling OSPFv3 Graceful Restart..............................................................................................716
OSPFv3 Authentication Using IPsec........................................................................................... 719
Troubleshooting OSPFv3............................................................................................................726
37 Policy-based Routing (PBR)......................................................................... 728
Overview............................................................................................................................................728
Implementing Policy-based Routing with Dell Networking OS..................................................... 729
Configuration Task List for Policy-based Routing...........................................................................730
PBR Exceptions (Permit)............................................................................................................. 730
Create a Redirect List........................................................................................................................ 731
Create a Rule for a Redirect-list........................................................................................................731
Apply a Redirect-list to an Interface using a Redirect-group......................................................... 733
Show Redirect List Configuration...............................................................................................734
Sample Configuration.......................................................................................................................735
Create the Redirect-List GOLDAssign Redirect-List GOLD to Interface 2/11View
Redirect-List GOLD.....................................................................................................................736
38 PIM Sparse-Mode (PIM-SM).........................................................................740
Implementation Information............................................................................................................740
Protocol Overview............................................................................................................................740
Requesting Multicast Traffic....................................................................................................... 740
Refuse Multicast Traffic............................................................................................................... 741
Send Multicast Traffic..................................................................................................................741
Configuring PIM-SM......................................................................................................................... 742
Related Configuration Tasks.......................................................................................................742
Enable PIM-SM..................................................................................................................................742
Configuring S,G Expiry Timers..........................................................................................................743
Configuring a Static Rendezvous Point........................................................................................... 744
Overriding Bootstrap Router Updates........................................................................................745
Configuring a Designated Router.....................................................................................................745
Creating Multicast Boundaries and Domains.................................................................................. 746
39 PIM Source-Specific Mode (PIM-SSM)....................................................... 747
Implementation Information............................................................................................................ 747
23