Scanning With the Machine7-14
2 Use the keypad to type in the number (between 1 and 250) for the speed
dial destination, and then press the Select key.
The information registered for the speed dial destination appears for two
seconds.
3 Press the Select key again.
If an FTP address or an SMB address was selected, the destination
address is specified.
4 If an e-mail address was selected, press the + or , key to select [FIN-
ISH], and then press the Select key.
d
To add an additional e-mail address, select [ADD] in step 4, and
then specify the destination. When sending the data to an FTP
address or SMB address, multiple addresses cannot be specified.
To check the specified e-mail address, select [CHECK/EDIT] in
step 4. To delete an address, select [CHECK/EDIT] in step 4, and
then continue with step 2 of "Deleting a Specified Destination
Address".
Selecting a Group Dial Destination
A maximum of 20 group dial destinations can be registered on this machine.
(A maximum of 50 e-mail addresses can be registered with one group.) Fol-
low the procedure described below to specify e-mail addresses from the
registered group dial destinations as the recipient of the scan data.
d
For details on registering e-mail addresses as group dial destinations,
refer to “Registering Group Dial Destinations” on page 7-25.
d
A group dial destination containing a telephone number cannot be
used in Scan mode.
1 With the main screen (Scan mode) or [Can Use AddressBook] displayed,
press the Addressbook key three times so that [GROUP DIAL] appears.
2 Use the keypad to type in the number (between 1 and 20) for the group
dial destination, and then press the Select key.
The information registered for the group dial destination appears for two
seconds.
3 Press the Select key again.
To Next Page
Loading...
