Scanning With the Machine 7-19
Editing a Specified Destination Address
A specified destination e-mail address can be edited.
d
FTP addresses, SMB addresses and addresses registered as speed
dial destinations or group dial destinations cannot be edited.
1 In the main screen (Scan mode), press the + or , key to select the cur-
rent data destination setting, and then press the Select key.
2 Press the + or , key to select [CHECK/EDIT], and then press the Select
key.
3 Press the + or , key to select the e-mail address to be edited, and then
press the Select key.
4 Use the keypad to edit the e-mail address, and then press the Select
key.
d
For details on entering/editing text, refer to “Entering Text” on
page 12-8.
5 To finish editing addresses, press the Back key.
6 Press the + or , key to select [FINISH], and then press the Select key.
Deleting a Specified Destination Address
A specified destination address (e-mail address, FTP address or SMB
address) can be deleted.
d
Changes made with this procedure will not be applied to the original
data (speed dial destination, group dial destination, etc.).
1 In the main screen (Scan mode), press the + or , key to select the cur-
rent data destination setting, and then press the Select key.
2 To delete an e-mail address, press the + or , key to select [CHECK/
EDIT], and then press the Select key. Then, press the + or , key to
select the address to be deleted. To delete an FTP address or SMB
address, continue with step 3.
3 Press the Stop/Reset key.
4 Press the + or , key to select [YES], and then press the Select key.
The selected address is deleted.
d
If all specified addresses are deleted, the main screen is dis-
played.
5 To delete another address, repeat the procedure from step 2.
6 To finish deleting addresses, press the Back key.
7 Press the + or , key to select [FINISH], and then press the Select key.
To Next Page
Loading...
