Scanning With the Machine7-30
Setting Duplex (Double-Sided) Scanning
Double-sided document pages can be scanned with the ADF.
d
These settings are available only if the document is loaded in the ADF.
If the document is scanned without being loaded in the ADF, [1-SIDE]
is automatically selected, and the document is scanned from the orig-
inal glass.
d
This setting is available only if [PDF] is selected as the data format for
the scan image.
1 In the main screen (Scan mode), press the + or , key to select the cur-
rent simplex/duplex (single-sided/double-sided) setting, and then press
the Select key.
2 Press the + or , key to select [2-SIDE], and then press the Select key.
3 Press the + or , key to select [LONG EDGE] or [SHORT EDGE], and then
press the Select key.
The main screen (Scan mode) appears again.
d
For details on [LONG EDGE] and [SHORT EDGE], refer to “Duplex
(Double-Sided) Copying From the ADF” on page 6-11.
4 Specify the desired scan settings.
5 Load the document into the ADF for the front side to be scanned.
6 To scan color scans, press the Start (Color) key. To print monochrome
scans, press the Start (B&W) key.
The front side of the document is scanned.
7 Load the document into the ADF for the back side to be scanned, and
then press the Select key.
The back side of the document is scanned.
To Next Page
Loading...
