Scanning With the Machine7-24
Editing/Deleting Speed Dial Destinations
Information registered as a speed dial destination can be edited or deleted.
d
Machine key operations cannot be used to edit/delete an FTP
address or SMB address registered as a speed dial destination.
These addresses can be edited/deleted with Local Setup Utility (LSU)
or Web Connection. For details, refer to the [Reference Guide] on the
Documentation CD/DVD.
1 In the main screen (Scan mode), press the + or , key to select [UTILITY],
and then press the Select key.
2 Press the + or , key to select [DIAL REGISTER], and then press the
Select key.
3 Press the + or , key to select [SPEED DIAL], and then press the Select
key.
4 Use the keypad to type in the number (between 1 and 220) for the speed
dial destination to be edited/deleted, and then press the Select key.
The information currently registered for the speed dial destination
appears for two seconds.
5 Press the + or , key to select [EDIT] to edit information or [DELETE] to
delete the destination, and then press the Select key.
If [DELETE] was selected, the settings are deleted, and the [DIAL REGIS-
TER] menu appears again.
6 Use the keypad to edit the registration name, and then press the Select
key.
d
For details on entering/editing text, refer to “Entering Text” on
page 12-8.
7 Use the keypad to edit the e-mail address, and then press the Select
key.
The edited settings are saved, and the [DIAL REGISTER] menu appears
again.
d
If the edited speed dial destination is registered in the favorite list
or with a group dial destination, a confirmation message asking
whether or not to keep the destination registered as it is appears
after the operation in step 7 is performed. To keep the destination
registered as it is, select [YES]. To cancel the registration, select
[NO].
To Next Page
Loading...
