Scanning With the Machine 7-15
4 Press the + or , key to select [FINISH], and then press the Select key.
d
To add an additional e-mail address, select [ADD] in step 4, and
then specify the destination.
To check the specified e-mail address, select [CHECK/EDIT] in
step 4. To delete an address, select [CHECK/EDIT] in step 4, and
then continue with step 2 of "Deleting a Specified Destination
Address".
Selecting From the Address Book
The speed dial destinations and group dial destinations registered on this
machine are saved in the address book. Follow the procedure described
below to specify an address (e-mail address, FTP address or SMB address)
from the address book as the recipient of the scan data.
d
This feature is available only if data has been registered in the
address book.
1 With the main screen or [Can Use AddressBook] displayed, press the
Addressbook key four times so that [ADDRESS BOOK] appears.
2 Press the + or , key to select [LIST], and then press the Select key.
A list of the address book contents appears.
3 Press the + or , key to select the desired data, and then press the
Select key.
4 Press the Select key again.
If an FTP address or an SMB address was selected, the destination
address is specified.
5 If an e-mail address was selected, press the + or , key to select [FIN-
ISH], and then press the Select key.
d
To add an additional e-mail address, select [ADD] in step 5, and
then specify the destination. When sending the data to an FTP
address or SMB address, multiple addresses cannot be specified.
To check the specified e-mail address, select [CHECK/EDIT] in
step 5. To delete an address, select [CHECK/EDIT] in step 5, and
then continue with step 2 of "Deleting a Specified Destination
Address".
To Next Page
Loading...
