Scanning With the Machine7-22
4 Use the keypad to type in the number (between 1 and 220) for the speed
dial destination, and then press the Select key.
5 Press the + or , key to select [MANUAL SETTING], and then press the
Select key.
d
If an LDAP server is not specified, step 5 is skipped.
6 Use the keypad to type in the registration name, and then press the
Select key.
d
For details on entering/editing text, refer to “Entering Text” on
page 12-8.
d
A maximum of 20 characters can be entered.
7 Use the keypad to type in the e-mail address, and then press the Select
key.
The settings are registered, and the [DIAL REGISTER] menu appears
again.
d
A maximum of 64 characters can be entered.
Registering Speed Dial Destinations (LDAP Search)
E-mail addresses can be registered as speed dial destinations by using
information on the LDAP server. A maximum of 250 speed dial destinations
can be registered.
d
To connect to an LDAP server, settings for [LDAP SETTING] must be
specified. For details, refer to the [Reference Guide] on the Documen-
tation CD/DVD.
d
Machine key operations cannot be used to register an FTP address or
SMB address as a speed dial destination. These addresses can be
registered with Local Setup Utility (LSU) or Web Connection. For
details, refer to the [Reference Guide] on the Documentation CD/
DVD.
d
Speed dial destination numbers 221 to 250 are reserved for register-
ing FTP addresses and SMB address from Local Setup Utility (LSU)
or Web Connection.
1 In the main screen (Scan mode), press the + or , key to select [UTILITY],
and then press the Select key.
2 Press the + or , key to select [DIAL REGISTER], and then press the
Select key.
3 Press the + or , key to select [SPEED DIAL], and then press the Select
key.
To Next Page
Loading...
