Scanning With the Machine7-18
d
To narrow down the search results, press the Back key, and then
perform step 4 again.
6 Press the Select key again.
7 Press the + or , key to select [FINISH], and then press the Select key.
d
To add an additional e-mail address, select [ADD] in step 7, and
then specify the destination. To edit the specified e-mail address,
select [CHECK/EDIT] in step 7, and then continue with step 2 of
"Editing a Specified Destination Address". To delete a specified
e-mail address, select [CHECK/EDIT] in step 7, and then continue
with step 2 of "Deleting a Specified Destination Address". The
address cannot be edited.
Specifying Multiple Destination Addresses
A destination address can be added if a destination e-mail address is speci-
fied.
d
If an FTP address or an SMB address was selected, multiple destina-
tion addresses cannot be specified.
1 In the main screen (Scan mode), press the + or , key to select the cur-
rent data destination setting, and then press the Select key.
2 Press the + or , key to select [ADD], and then press the Select key.
3 Specify the destination address.
d
For details on typing in an e-mail address, refer to “Directly Enter-
ing the E-mail Address” on page 7-12.
For details on selecting from the favorite list, refer to “Selecting
From the Favorite List” on page 7-13.
For details on selecting a speed dial destination, refer to “Select-
ing a Speed Dial Destination” on page 7-13.
For details on selecting a group dial destination, refer to “Select-
ing a Group Dial Destination” on page 7-14.
For details on selecting from the address book, refer to “Selecting
From the Address Book” on page 7-15.
For details on searching the address book, refer to “Searching the
Address Book” on page 7-16.
For details on searching an LDAP server, refer to “Searching an
LDAP Server” on page 7-17.
To Next Page
Loading...
