Diamond DA 62 - Page 213

Normal Operating
Procedures
DA 62 AFM
GFC 700 Operation During Approach and Landing
a) VOR
1. Navigation source . . . . . . . . . . . . . . . . . . . . . select VOR using CDI button on
PFD
2. Course bearing pointer . . . . . . . . . . . . . . . . . set using course knob
3. Intercept heading . . . . . . . . . . . . . . . . . . . . . . establish in HDG or ROL mode (if
required)
4. Mode controller . . . . . . . . . . . . . . . . . . . . . . . select APR on mode controller
5. Green or white VAPP annunciation . . . . . . . . note on PFD
6. Vertical mode and reference . . . . . . . . . . . . . select on mode controller
NOTE
If the Course Deviation Indicator (CDI) is greater than one
dot from center, the autopilot will arm the VAPP mode and
indicate VAPP in white on the PFD. The pilot must ensure
that the current heading will result in a capture of the selected
course. If the CDI is one dot or less from center, the autopilot
will enter the capture mode when the VAPP button is pressed
and annunciate VAPP in green on the PFD.
END OF CHECKLIST
Page 4A - 56 Rev. 0 11-Jan-2019 Doc. No. 11.01.05-E