Diamond DA 62 - Page 214

DA 62 AFM
Normal Operating
Procedures
b) ILS
1. Navigation source . . . . . . . . . . . . . . . . . . . . . select LOC using CDI button on
PFD
2. Course bearing pointer . . . . . . . . . . . . . . . . . set using course knob
3. Intercept heading. . . . . . . . . . . . . . . . . . . . . . establish in HDG or ROL mode (if
required)
4. Mode controller . . . . . . . . . . . . . . . . . . . . . . . select APR on mode controller
5. Green or white LOC and GS annunciation . . note on PFD
6. Vertical mode and reference . . . . . . . . . . . . select on mode controller
NOTE
When the selected navigation source is a valid ILS, glideslope
coupling is automatically armed when tracking the localizer.
The glideslope cannot be captured until the localizer is
captured. The autopilot can capture the glideslope from
above or below the glideslope.
END OF CHECKLIST
Doc. No. 11.01.05-E Rev. 0 11-Jan-2019 Page 4A - 57