Introduction Manual D900
49-MD900EN05
6
1.5. INSTALLATION OF THE SCALE
Follow the instructions below to ensure correct installation and operation of the scales.
1. Check that the mains voltage corresponds to that stated on the specifications label on the scales and
that it does not fluctuate in excess of 10% of nominal voltage.
2. Make sure that the scales can be connected to a nearby socket that is easy to access. We recommend
that the socket should be provided with differential breaker, thermal-magnetic trips, and ground.
3. Make sure that other equipment such as refrigerators, cutting machines, etc. are not connected to same
socket.
4. Only use the scales in areas that comply with the room temperature values stated on the specifications
label (-10ºC to 40ºC).
5. Peripheral devices connected to the equipment must be protected against fluctuation peaks of above
8A 100VA.
6. The scales must be placed on a stable, level surface.
7. No objects must come into contact with the dish.
8. Avoid extreme temperatures. Do not place the scales in direct sunlight or close to air conditioning
vents.
9. These scales have not been designed as waterproof scales. Therefore, avoid high levels of humidity
since this might cause condensation. Protect from rain and avoid direct contact with water. Do not
spray water on the scales or submerge in water. If the scales get wet, switch off the power supply
immediately.
The scales leave the factory prepared for retail sales. Therefore, labels can be printed at below the
minimum limit.
In the case of pre-packaging activities, in accordance with legislation in force (Standard EN 45501 and
Directive 2009/23/EC), this type of equipment may only be used if packages are above the minimum limit.
The scales can be set up for specific use for pre-packaging tasks. Consult your supplier or technical
assistance service.
WARNING:
Disconnect the cable of the mains supply of the scale from the electrical socket if the scale needs to be
opened or manipulated.
To Next Page
Loading...
Need help?
General
