Dibal D900 Series - 2.8.3.4.3 Totals levels; 2.8.3.5.Selection of a default vendor

Operation Manual D900
49-MD900EN05
30
2.8.3.4.3 Totals levels
D900 scales have three totals levels. When a totals label is printed for one level, the data automatically
accumulates on the totals label on the next level up.
Each accumulated level has an associated label format and EAN code format. If there is not an EAN total
code defined, is taken the label default value “Ean-13 format label”.
If the article is not changed at accumulation level 1, the label fields that correspond to the PLU itself (code,
name, price, etc.) will show PLU data.
In this case too, level 1 labels will show the expiry date even if the parameter Allow label mode is not set
to ‘3 – It obliges. With accumulation of totals per article’ (see section 3.8.2.8.5 Allow label mode).
However, if the article has changed, nothing will be shown in these fields, except in the name field, which
will show "Accumulated total".
If parameter Allow label mode has a value of ‘3 – It obliges. With accumulation of totals per article’, then
PLU data will be shown at all levels. Furthermore, in this case, when an article is changed, the
accumulative totals at all three levels will be deleted.
2.8.3.5.Selection of a default vendor
It is possible to select a default sales assistant so that the sales assistant key does not have to be
pressed. To do this, parameter must be set-up (User menu  Settings  Working Modes  Automatic
Weighing, see paragraph. 3.10.4.2 Automatic Weighing).
A. If the configuration parameter automatic weighing is ‘WITH SEL MEMO’:
Working in label mode:
The automatic weighing mode will be effected with the default memory.
Memorizations cannot be effected on a memory that is being used by another machine, because the
latter will block the memory.
B. If the configuration parameter automatic weighing is ‘WITH SEL MEMO’:
Working in label mode:
The automatic weighing mode will be effected without the default memory.
2.8.4.Self Service Mode
The way it works in this mode is performed by placing a weight on the plate and when pressing the
corresponding key label. The label of the required product is printed without requiring the intervention of a
vendor.
In self-service mode only direct keys are operative.
To print a label:
1. Put the product on the plate.
2. Press the PLU key.
3. The scale saves the operation and prints the label.
To enable Self Service Mode, see paragraph 2.4 Working Mode selection.
All the operations done in the scale will allocated as sales to the memory 1 or, if the
scale is configured as slave, to the memory Slave Number +1.