Maintenance Manual D900
49-MD900EN05
102
3.9.4.EAN Settings
3.9.4.1.Barcode in Ticket
This is to inform the scale if it is to issue a bar code, and when it is to do so:
‘NO’ – No bar code.
‘YES WITH AMNT ≥ 0’ – Bar code on the receipt when the total is positive. (Default value)
‘YES IF AMNT ≤ 0’ – Bar code on the receipt always positive. If the total is negative, a zero shows.
‘YES – ABS AMOUNT’ – Bar code always, with the absolute value of the amount being written in.
3.9.4.2.Section Barcode in Register Voucher
The scale permits a voucher to obtain specific information of the sales by section.
‘0 –NO BARCODES PER SECTION ’ – Barcodes per section are not printed.
‘1 – ONLY ONE RECEIPT AND VOUCHER PER SECTION’ – In one receipt the information about all
the sections is printed. In the Voucher is obtained the barcode for each section of which have been
made sales on the receipt.
‘2 – RECEIPT AND VOUCHER PER SECTION’ – One receipt and a voucher are printed by section,
which prints the barcode associated with the corresponding section.
‘3 – RECEIPT PER SECTION AND NO VOUCHERS’ – A receipt is printed by section (without
voucher), which prints the barcode associated with the corresponding section.
The code of each section is programmable (see paragraph 3.4.1 Sections) being by default if there is
not assigned another one 2KKNNNNEEEEE.
3.9.4.3.EAN 13 Ticket Format
With this parameter you can determine if the bar code is to be printed on both the receipt and the label:
‘DEFAULT’ – Format by default of the bar code. (Default value)
‘F.80’ – Special format in receipt mode.
Here the overall EAN13 bar code is defined for the receipt. It is called the special bar code.
The numbers are symbolized directly on the bar code, and the meaning of the different letters is shown in
table 3-2
To Next Page
Loading...
Need help?
General
