AnywhereUSB® Plus User Guide
12
Configure the device to reboot when a failure is detected 118
Disable SureLink 127
Example: Use a ping test for WAN failover from Ethernet to cellular 130
Using Ethernet devices in a WAN 133
Using cellular modems in a Wireless WAN (WWAN) 133
Configure a Wide Area Network (WAN) 155
Configure a Wireless Wide Area Network (WWAN) 162
Show WAN and WWAN status and statistics 172
Delete a WAN or WWAN 174
Default outbound WAN/WWAN ports 175
Local Area Networks (LANs) 176
About Local Area Networks (LANs) 177
Configure a LAN 177
Show LAN status and statistics 183
Delete a LAN 185
DHCP servers 187
Create a Virtual LAN (VLAN) route 203
Default services listening on LANports 206
Bridging 207
Edit the preconfigured ETH2 bridge 208
Configure a bridge 211
Console port
Services
Allow remote access for web administration and SSH 217
Configure the web administration service 220
Configure SSHaccess 229
Use SSH with key authentication 236
Generating SSH key pairs 236
Configure DNS 237
Show DNS server 243
Simple Network Management Protocol (SNMP) 245
SNMP Security 245
Configure Simple Network Management Protocol (SNMP) 245
Download MIBs 249
Location information 251
Configure the location service 252
Configure the device to use a user-defined static location 253
Configure the device to accept location messages from external sources 255
Forward location information to a remote host 259
Configure geofencing 265
Show location information 277
System time 279
Configure the system time 279
Manually set the system date and time 282
Network Time Protocol 283
Configure the device as an NTP server 283
Show status and statistics of the NTP server 288
Configure a multicast route 289
Ethernet network bonding 293
Enable service discovery (mDNS) 295
Use the iPerf service 299
To Next Page
Loading...
Need help?
General