AnywhereUSB® Plus User Guide
13
Example performance test using iPerf3 303
Configure the ping responder service 304
Example performance test using iPerf3 307
User authentication
AnywhereUSB Plus user authentication 310
User authentication methods 310
Add a new authentication method 312
Delete an authentication method 314
Rearrange the position of authentication methods 315
Authentication groups 317
Change the access rights for a predefined group 318
Add an authentication group 320
Delete an authentication group 324
Local users 326
Change a local user's password 327
Configure a local user 329
Delete a local user 336
Terminal Access Controller Access-Control System Plus (TACACS+) 339
TACACS+ user configuration 340
TACACS+ server failover and fallback to local authentication 341
Configure your AnywhereUSB Plus device to use a TACACS+ server 341
Remote Authentication Dial-In User Service (RADIUS) 345
RADIUS user configuration 346
RADIUS server failover and fallback to local configuration 346
Configure your AnywhereUSB Plus device to use a RADIUS server 347
LDAP 350
LDAP user configuration 352
LDAP server failover and fallback to local configuration 353
Configure your AnywhereUSB Plus device to use an LDAP server 353
Configure serial authentication 358
Disable shell access 360
Set the idle timeout for AnywhereUSB Plus users 361
Example user configuration 363
Example 1: Administrator user with local authentication 363
Example 2: RADIUS, TACACS+, and local authentication for one user 365
Firewall
Firewall configuration 372
Create a custom firewall zone 372
Configure the firewall zone for a network interface 374
Delete a custom firewall zone 374
Port forwarding rules 375
Configure port forwarding 375
Delete a port forwarding rule 380
Packet filtering 382
Configure packet filtering 382
Enable or disable a packet filtering rule 386
Delete a packet filtering rule 387
Configure custom firewall rules 389
Configure Quality of Service options 391
To Next Page
Loading...
Need help?
General