Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
135
10. For Antennas, select whether the modem should use the main antenna, the auxiliary antenna,
or both the main and auxiliary antennas.
11. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Modem configurations are enabled by default. To disable:
(config)> network modem modem enable false
(config)>
4. Set the SIMslot that should be used by the modem:
(config)> network modem modem sim_slot value
(config)>
where value is one of the following:
n
any: Uses either SIMslot.
n
1: Uses the first SIM slot.
n
2. Uses the second SIMslot.
The default is any.
5. If sim_slot is set to any, set the SIMslot that should be considered the preferred slot for this
modem:
(config)> network modem modem sim_slot_preference value
(config)>
where value is one of the following:
n
none: Does not consider either SIM slot to be the preferred slot.
n
1: Configures the first SIM slot as the preferred SIMslot.
n
2. Configures the second SIM slot as the preferred SIMslot.
In the event of a failover to a non-preferred SIM, or if manual SIM switching is used to switch to
a non-preferred SIM, the modem will attempt to reconnect to the SIM in the preferred SIMslot.
The default is none.
6. Set the maximum number of interfaces. This is used when using dual-APN SIMs. The default is
1.
To Next Page
Loading...
Need help?
General