Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
149
4. If carrier section mode is set to manual or manual_automatic, set the network PLMN ID:
(config)> network interface modem modem operator plmn_ID
(config)>
Note You can use the modem scan command at the Admin CLI to scan for available carriers
and determine their PLMN ID. See Scan for available cellular carriers for details.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Scan for available cellular carriers
You can scan for available carriers and determine their network PLMN ID by using the modem scan
command at the Admin CLI.
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access.
2. From the main menu, click Status > Modems.
3. croll to the Connection Status section and click SCAN.
The Carrier Scan window opens.
4. When the Carrier Scan window opens, the results of the most recent previous scan are
displayed. If there is no previous scan available, or to refresh the list, click SCAN.
5. The current carrier is highlighted in green. To switch to a different carrier:
To Next Page
Loading...
Need help?
General