AT commands
Digi TransPort User Guide 123
\AT command: Ignore invalid AT commands
This command is a work-around for use with terminals that generate large amounts of
extraneous text. If not ignored, this text can cause many error messages to be generated by the
router, and may result in a communications failure. To turn on this feature, type the following
command:
at\at=1
To turn off the feature, type the following command:
at\at=0
When this feature is turned on, the ASY port ignores all commands except real AT commands. As
with other ASY modes this can be saved by AT&W but is not included in the AT&V status display.
To determine whether or not this mode is enabled type:
at\at ?
The router will display 0 if the feature is Off, 1 if it is On.
\LS command: Lock speed
The AT\LS command is used to lock the speed and data format of the port at which it is entered
to the current settings so that the non-AT application commands may be used.
To Next Page
Loading...
