Event Settings parameters
Digi TransPort User Guide 587
Event Settings parameters
The router maintains a log of events in the LOGCODES.TXT pseudo file. When an event of a
specified or lower priority level occurs, a syslog message, an email alert, or SMS alert can be sent
to a pre-defined address. The Configuration > Alarms > Event Settings menu has the following
sub-menu items:
• Email Notifications
• SNMP Traps
• SMS Messages
• Local Logging
• Syslog Messages
• Syslog Server n
To configure the Event Settings, set the following parameter values:
Only log events with a log priority of at least n
Enables a filter that ensures that only events having a specified severity or lower level are
logged.
Do not log the following events
A numerical list of comma-separated values specifying events to be excluded from the log.
These numerical values can be found in the eventlog.txt file on the router.
After power up, wait s seconds before sending Emails, SNMP traps, SMS or Syslog messages
The delay, in seconds, after power-up that the router should wait before sending any alert
messages. This is useful when the sending of those items would fail if sent too soon after the
router powers up because the underlying interface that would be used has not completed
initialization.
Include event number in the event log and Email, SNMP traps or Syslog messages
If enabled, event numbers from the logcodes.txt file are included.
To Next Page
Loading...
